Radiant heat under hardwood makes for cozy room
Q. My elderly mother is moving in with us and I need more heat for her bedroom. Would a radiant floor system be comfortable with a strip hardwood top and is a wet or dry system best to use?
A. Your mother is a lucky, and soon to be comfortable, woman. Radiant heating underneath a hardwood floor makes for a very cozy, warm bedroom. This type of system uses the entire floor surface as a low-temperature radiator for very even heating.
Radiant floor heating is one of the most healthy systems, particularly for the elderly. They often have respiratory problems similarly to younger people with allergies and asthma. With no blowing air from ductwork, the room air stays cleaner.
An old leaky duct system can allow dust and mold spores to be drawn in leaks in the basement or utility room and then carried to the all the other rooms of the house. Large hot water radiators or baseboard radiators are not as bad, but they do create air flow patterns which may carry dust.
A wet radiant floor system is one in which the hot water PEX (cross-linked polyethylene) tubing is embedded in a concrete or light gypsum floor. A dry floor generally uses special flooring panels with grooves to hold the PEX tubing in place. If you have access to the underside of the floor, the hot water tubing can be attached underneath the existing floor between the joists.
If you are planning to do some of the installation work yourself, a dry radiant floor is much easier to install. You can attempt a wet floor, but it can be difficult to make it smooth and even unless you are experienced at working with concrete and cement.
Several companies make the dry floor grooved panels specifically for this type of retrofit application. These panels create a solid base for the strip hardwood flooring you plan to use to finish the floor.
Before running out and buying these panels, have a contractor design the system for you. The amount of tubing needed for proper heating depends upon the size of the room, wall/ceiling insulation, windows, etc. Contractors do the same type of heat loss analysis as they would do when sizing a new furnace.
Be sure to tell the contractor you are planning to install hardwood flooring over the radiant heating. This is important because you do not want the hardwood surface to get above about 85 F. Higher temperatures can overly dry the wood over time. In order to keep the temperature this low, the contractor may specify more tubing with lower temperature water flowing through it.
Also, have the contractor select and design the control system. A programmable type is best, particularly for a bedroom which is used primarily at night. Keep in mind, it takes much longer for a radiant floor to heat up than it does when you turn up the thermostat on a forced air furnace.
Once the system is totally designed, you can install the PEX tubing into the grooves in the floor panels. Gun a generous bead of silicone caulk into the groove and then snap the tubing into it. Sometimes it helps to gently tap the tubing with a rubber mallet to insure it is seated properly in the groove.
Starcott Media Services